DIY Installation Guide

Four-Step Process for Installing Decorative Wall Panels

Step 1: Measure and Plan

  • Take precise measurements of the wall's height and width, noting any obstacles such as electrical sockets and pipes.
  • Lay the panels out on the floor to determine the optimal starting point and minimise cuts.
  • Mark a vertical reference line on the wall to ensure the first panel is perfectly aligned.

Step 2: Prepare and Trim

  • Ensure the wall surface is clean, dry, and level.
  • Use a fine-tooth saw to cut the starter, edge, and corner trims to the required lengths.
  • Attach the trims using a strong panel adhesive, checking alignment with a spirit level.

Step 3: Attach the Panels

  • Apply vertical beads of adhesive to the back of the first panel.
  • Insert the tongue of the panel into the trim, pressing it firmly against the wall and leveling it.
  • Continue this process for the remaining panels, ensuring each tongue-and-groove joint fits tightly for a seamless appearance.

Step 4: Finalise and Seal

  • Carefully cut around switches or pipes using a jigsaw or utility knife; test the fit before securing.
  • Install the final edge or universal trims, then apply color-matched silicone to corners and joints for a watertight seal.
  • Clean the panels, remove any protective film, and allow the adhesive to fully cure.